1-25 of 8,163 cars
1961 corvette project car will ship anywhere worldwide. 1961 vette 283 correct heads intake and exhaust mains. All org body, the is a great...
...a two-barrel carburetor and sends power to the rear or all four wheels through a three-speed manual transmission and two-speed transfer case.
1932 Ford project car, new fiberglass body on new show chassis, have most parts to complete. Includes gauge set, wiring harness, all glass...
...all found to turn freely. Multiple undercarriage photos have been provided showing the condition of various chassis and suspension components
This 1973 Ford Bronco is a running project that was reportedly purchased new by the owner’s grandfather at West Valley Ford in Magna, Utah...
1969 Ford Mustang Coupe White RWD Manual modified vehicle with updates This is a project car I ran out of time and can’t finish. My loss is...
...All factory instrumentation is present, and the 74,458 miles shown are believed correct, though this cannot be verified with documentation...
...all around. Tan steel 14? wheels wear white hubcaps and 205/70 Hankook Kinergy ST tires with 2020 date codes. Rust and pitting are noted...
...tires, and a set of chrome hubcaps will accompany the car. Factory equipment included front disc brakes and coil springs at all four corners.
...body Nice interior, leather can be redye then conditioner, driver seat has some small tears but not bad at all. Motor and transmission are good
This 1964 Porsche 356C is a non-running project that was acquired by the seller approximately 26 years ago and has since been kept in storage...
...engine and original numbers matching 727 AT transmission, It has always been a very nice and well cared for car. It was never an abused project...
...brakes, power steering, strong motor and AC all make driving this car a pleasure. You could take this to any show and get tons of compliments.
...addition of a winch, roll bar, locking center console, and more. Just over 1,600 miles were reportedly added since completion of the project.
...was to do a full restoration but I now need the space for another project. The car needs new floors but is a great candidate for restoration.
1954 lincoln capri convertible with its original running gear this car was frame off restored about 5 years ago and 90% done frame us all done...
...H724 tires. The brake master cylinder was reportedly repaired under current ownership. Equipment includes a front sway bar and disc brakes all...
...on the freeway-3” lower front beam with disc brakes-new tires. New header with new exhaust-all lights work, runs, drives and stops-Nice interior
...aluminum cylinder heads, an Edelbrock four-barrel carburetor, and an MSD electronic ignition system, and drive is transferred to two or all...
...Eibach springs, polyurethane bushings, a radio, and air conditioning. Approximately 500 miles have been added since completion of the project...
Two parts cars, many new and refurbished original parts, extensive fabrication work, and over 850 hours of labor went into the project...
...cars, with an independent front setup with coil springs and a live-axle rear with leaf springs, as well as Koni shock absorbers all around.
...all four wheels through a four-speed manual transmission and a dual-range transfer case. 156k Miles Shown 4.2-Liter Inline-Six Four-Speed...
1968 Volvo 122 122S Coupe 65383 Miles Stunning 68’ Volvo 122S Coupe. This was my personal project What you’re getting with this coupe isn’t...
...SPICA fuel injection system, suspension, brakes, and interior. Repainted in its original Alfa Red in the mid 1990s just before the project...
Get notified when we have new listings available for all project
1 2 3 4 5 Next »
Receive alerts for this search
Manage my alerts
We use cookies to personalize your experience. If that’s okay, just keep browsing. More info
Tell us how we can improve