Fed

...climate control, a Borla exhaust, a wind deflector, and a Bluetooth-capable stereo head unit. Service in 2020 included installing an oil-fed...

...1ZZ-FED inline-four features variable valve timing and was factory rated at 138 horsepower and 127 lb-ft of torque. Power is delivered to the...

...fed by a two-barrel carburetor topped with an oil-bath air cleaner. The engine’s top end is said to have been refurbished in 2015. A...

...fed through a single downdraft carburetor. An oil change was performed and the spark plugs and ignition wires were replaced in May 2021 per...

...always fed high octane fuel and synthetic oil. Slight scuff on passenger wheel well and mar on passenger seat, otherwise in great condition.

...fed fuel by a pair of 39 DC03 weber carburetors. The correct setup for this car. Eligible for the most interesting and exciting international...

...fed by a single Carter carburetor. A fluid service is said to have been completed, and the six-volt battery was replaced in 2021. Power is...

...fed by a single-barrel downdraft carburetor with a chrome air cleaner. The thermostat, hoses, and spark plug wires have been changed aLording...

...pressure-fed timing chain tensioners, and an external oil cooler mounted in the front fender well. A valve adjustment was reportedly...

...fed by a FiTech Go Street fuel injection system. A replacement electrical harness and electronic ignition setup were also installed aLording...

Power is provided by a 4,455cc Type 183 inline-six fed by triple Solex carburetors and paired with a four-speed Cotal pre-selector gearbox...

...they made only 989 1972 911S Targa’s, the Early S Registry has only 70 of them registered. Pressure fed 930 tensioners were added around 1979.

...fed by a single carburetor equipped with an oil bath air cleaner and features an electric fuel pump. Power is sent to the rear wheels through...

...fed by dual Holley four-barrel carburetors. The engine block casting number reads C5AE-H, indicating a 1965 build. An oil change was carried...

...fed by twin SU carburetors and has been serviced with an oil change according to the seller. Power is sent to the rear or all four wheels...

...pressure-fed IMS bearing kit has reportedly been installed during previous ownership. The radiator ducts were cleaned, an oil change...

Biggest change is in the engine bay, where a 185HP Polo 4-cylinder is effectively a 964 engine with two cylinders lopped off but fed by Weber...

...by black LeMans stripes and red pinstriping. A Smeding Performance 427 stroker engine attached to a TKO600 5 speed manual trans being fed...

...fed by dual SU carburetors and was rated at 150 horsepower and 173 lb-ft of torque when new. Fluids were reportedly flushed and rubber hoses...

...1ZZ-FED inline-four features variable valve timing and was factory rated at 138 horsepower and 127 lb-ft of torque. The seller states an oil...

...fed via a Carter carburetor with an electric choke. Additional modifications include an upgraded radiator, a 70-amp alternator, an SU...

...fed by an Edelbrock carburetor. Other equipment includes an aluminum intake manifold, an aluminum water pump, and an aluminum radiator with...

...fed by a 12-volt electrical system, four-wheel hydraulic drum brakes, bolt-on 17” wire wheels, red leather upholstery over staggered seating...

This stunning C2 convertible is so much fun to drive! Powered by a 454 cu in motor that is getting fed fuel by a Holley Sniper fuel injection...

...fed by a single Weber 38 downdraft carburetor on an aftermarket intake manifold. Power is routed to the rear or all four wheels through a...