Hydraulic setup

...setup. An A727 Torqueflite 3-speed automatic hustles power back to a Dana 60 4.10 posi rear, and of course all this frustration is taken out...

...setup and was factory-rated at 277 horsepower. Power is sent to the rear wheels through a four-speed Hydramatic Jetaway automatic...

...hydraulic clutch and a Ford 9” Positraction rear end with 3.70:1 gears. 674 Miles Shown, TMU Ford 347ci V8 Five-Speed Manual Transmission...

...The stock steel on and an electric with a custom radiator shroud. Has a 5-speed manual GM gearbox with hydraulic clutch and 12 Bolt Rear end.

...hydraulic dampers up front. Inside, the front bucket seats and rear bench are trimmed in pale blue and white upholstery with matching door...

...cars like the Eldorado, this special setup in the rear gives you a fully independent suspension. How many custom classic pickups have that?

...engine 1957 Chevrolet Belair, A Beautiful & professionally done Restoration! 468 Big Block engine w/ Aluminum heads. Roller rockers. Hydraulic...

...setup. The five-digit odometer shows just under 500 miles and reflects the mileage driven since completion of the project in 2017. True...

...setup. The interior has been redone in green leather along with tan carpeting. There is also a wooden dash that looks fantastic, along with...

...setup with tie down loops. Battery located to trunk. Classic Torq Thust wheels with correct center cap trim. Correct instrument pod. Carroll...

...McLeod hydraulic Throwout Bearing, Hurst shifter linkage, and Olds rearend, and a 327 S. B.C. with cragar manifold, and cragar 471 blower.

...was replaced by a higher-geared Burman unit of 3.5 turns lock-to-lock, which linked the input shaft and hydraulic valve by a torsion spring to

...hydraulic clutch, and a Ford 9' spinning 3.08 gears. This combination with the hearth thumping Hemi up front makes for a fantastic hot rod...

...hydraulic shock absorbers all around. The cabin was retrimmed during the restoration, retaining the original color indicated on the Jaguar...

...hydraulic assistance, and independent front suspension by use of torsion bars with semi-elliptic leaf spring rear suspension proved for a...

...ago at which time a new odometer was installed and set to zero. Power comes from a new ATK 351 roller engine with an Explorer serpentine setup...

...and travel, plus 6-point hydraulic landing gear and auto level system for easy setup and take down. Choose. Still available at ListedBuy!

1968 Chevrolet Nova SS Clone/Tribute. Not a true super sport! Engine is a 468ci date coded 1968, 12.5:1 compression 600+ lift hydraulic roller...

...and bronze-colored ram’s-horn exhaust manifolds. Power is sent to the rear wheels through a Tremec 5-speed manual transmission with a hydraulic...

...disc brakes with aluminum calipers, a Mullins Vega-style aluminum steering box, five-spoke alloy wheels with a spindle-mount front setup...

...then made its way east in 2016. Current owner added many upgrades and improvements which include coil over shocks, flames, a March pulley setup...

...hydraulic throwout bearing. This feeds an aluminum driveshaft on its way to the Winters Performance 9-inch floater rear with locker. The...

...hydraulic landing gear and auto leveling system, and stow away lots of outdoor gear in the Super Store-More 3-sided accessed basement with...

...setup easily. And the upgraded shower system, the hardwood window valances, the oversized kitchen pantry, the window above the master bed...

...setup. Also included is a Cummins Onan Micro Quiet gas generator, two deep-cycle MarineRV Group 31 batteries, a 1,000-watt inverter, and a...