Member

...member of this car was very particular and took proper care of his summer vacation home car. This car looks just like it did when it left the...

...member, it was clearly enjoyed in that ownership given the upgraded airbox and filter, aluminum radiator with electric fan, and modern...

...is sent to the rear wheels through a four-speed manual transmission, a custom driveshaft, and a Currie Enterprises 9″ housing, third member...

...system with ceramic-coated headers and Magnaflow mufflers. A rebuilt NV3550 five-speed manual transmission with a replacement cross member...

...member and exits from under the rear bumpers. The fiberglass body was refinished in its original Mille Miglia Red in 1998. Exterior features...

...Maximum Motorsports front K-member and tubular front control arms. The four-wheel disc brakes feature Brembo front calipers and drilled rot.

...member. Braking is handled by power-assisted front discs and rear drums. The cabin features front bucket seats and a rear bench upholstered...

...New alignment and tuning. A Tremec five speed has replaced the Toploader four-speed that originally came in the car and A new third member...

...Series III example that was delivered new to Sheikh Khalifa bin Salman Al-Khalifa, the first Prime Minister of Bahrain and a member...

...member. Braking is handled by power-assisted front discs and rear drums. The cabin features front bucket seats and a rear bench upholstered...

...back in the day. It has the correct 428 Cobra Jet C6 transmission with the "R" servo and cast iron tail shaft and correct C6 cross member...

...in April 2023, the front body pan, shell, and cross member were repaired with new metal panels before being refinished. Photos taken during va.

...Approximately 3.50:1. Posi. Waffle Case" 3rd Member (More Strength Ribs). 1975 Casting DateFront Wheels. 15" Rear Wheels. 15" Front Tires.

...member, and a seven-wire trailer harness. The seller notes a rock chip near the left headlight and another near the rear license plate...

...member, shock towers, and differential mounts before being refinished. Additional work is said to have included reupholstering the soft top...

1994 Land rover defender, #785 has no rust on it, none on the floors, and under doors, rear cross member is clean, as is underneath. Just had...

...cross-member was reportedly stripped to the bare metal and then repainted in gray. The suspension bushings, ball joints, shocks, tie rods...

...from the factory in Colorado Red and was repainted in two-tone blue over white in 1991. During the refurbishment, the front cross member...

...battery. Power is sent to the rear wheels through a three-speed automatic transmission and a Currie 9″ rear end with an aftermarket third member...

...with a Mopar K-member in addition to Strange Engineering double-adjustable shocks and struts, and stopping power is provided by Strange Eng.

...72 plymouth duster 440 727 8 -- -. 73 positraction new suspension all electrical components wiring. Welded frame connector reinforced K-member...

...up front and 275/40 out back. The front suspension was modified with a Magnum Force front K-member suspension and power rack and pinion steeri.

...body-henry ford steel, chopped 3 inches. Frame-Original Ford frame, fully boxed, chassis engineering front crossmember and center x member...

...Stopping power is provided by four-wheel disc brakes. The seller notes that the front cross-member should be replaced due to rust, and image.

...member, it was clearly enjoyed in that ownership given the upgraded airbox and filter, aluminum radiator with electric fan, and modern...