Project truck

This 1973 Ford Bronco is a running project that was reportedly purchased new by the owner’s grandfather at West Valley Ford in Magna, Utah...

...an aftermarket Smittybilt front push bumper and rear bumper, manually-locking hubs, air conditioning, and an aftermarket CD stereo. The truck...

...Land Rover Defender 90 is #1,672 of approximately 2,800 North American-Specification examples imported into the US for the model year. The truck...

...a 4.5-liter 1FZ-FE inline-six that is said to have rebuilt using performance pistons, Ferrea valves and springs, and a Crower cam kit. The truck...

Part of a multi-year project completed in November 2024 using a replacement steel body, a Patriot Classic 4×4 chassis, and a 5.0L Coyote V8...

...for the front is in good condition, and the factory cowl vent opens and closes as it should. It is a fine cruiser, or even a nice show truck

...4×4 pickup that was refinished in red and black under previous ownership and was acquired by the seller out of Vermont as an incomplete project...

...Rover 90 is a left-hand drive example that was imported to the US by the seller in June 2021 following a refurbishment in Italy. The project...

This 1967 Land Rover 109 Series IIA pickup truck was acquired by the seller out of Cooperstown, New York, in 2017 as an incomplete...

This 1968 Ford Bronco was acquired by the seller in January 2016 as a non-running project, and a subsequent three-year refurbishment was...

...by multiple clear coats. The digital odometer shows approximately 130 miles, reflecting the distance driven since completion of the project.

The truck has a small crack near bottom of glass, E-brake requires adjusting and to finish the project needs a better paint job. This truck...

...to a Tremec TR3650 five-speed manual transmission and a limited-slip differential. The vehicle was purchased by the seller in 2015 as a project...

This 1972 Chevrolet Suburban was acquired by the seller as an incomplete project in 2020, reportedly following over 40 years of ownership by...

This 1966 Ford Bronco was acquired in 2021 as a non-running project and subsequently underwent a refurbishment that involved refinishing the...

...300 miles on it. Rebuilt tranny. Fuel injection installed. Long bed. Project truck that is just about done (little odds and ends). Runs great.

Countless hours of body work went into this project, which has laser straight body panels, and is all steel. New floor pans were welded in...

Project truck, 75% complete. Body Completed Needs wiring completed. Needs bumpers & tail lights installed Mustang 2 front end 383 stroker V-8...

...with an odometer showing just over 500 miles, which represent the total driven since completion of the project. True mileage is unknown.

...truck until recently and would make a great daily driver. It could also be a project to restore to your liking or used as a farm or work truck.

This is an award winning restoration of a 1940 Ford pickup truck. It has been fully restored as close to factory condition as possible. Two...

Up for sale is an early square body that has an awesome 70’s look to it. The truck is finished in a nice dark poly green body and is really...

1956 Ford F100 PROJECT 1000 Miles 390 V8 3 Speed Automatic Offering great bones for the beginnings of your dream truck is this 1956 Ford F100...

1963 International Harvester Scout 80 Trophy Truck 1963 International Harvester Scout 80 (similar to the later 800 but produced in much lower...

1967 Chevrolet C20 Pickup Truck 350ci motor 4 Speed Manual 85316 Miles This 1967 Chevrolet C20 has the cool true workman style you want in an...